Home › Texas › Well Depth by County › Howard County
How Deep Are Wells in Howard County, TX?
The median residential well in Howard County is 110 ft deep, based on 587 completion reports filed with the Texas Water Development Board. Most fall between 60 and 260 ft; the deepest on record is 420 ft.
That is 172 ft shallower than the Texas state-wide average of 282 ft (an n-weighted average across every Texas county with reported data). Depth depends on local geology, your own site could sit well outside Howard County's typical range.
Source and method: Texas Water Development Board Submitted Driller's Reports database, extracted 2026-07-14. Figures include only wells recorded as residential (domestic) use, completed 2011 or later, with a reported depth between 15 and 2,000 ft (to exclude likely data-entry errors). TWDB itself notes well locations and data "are not verified by State staff and may be inaccurate," and neither TWDB nor this site independently verifies them. These are figures self-reported by licensed drillers to the state; treat this as a planning reference, not a guarantee for any specific property.
Howard County well depth at a glance
| Metric | Value |
|---|---|
| Median depth | 110 ft |
| Typical range (10th-90th pct) | 60-260 ft |
| Full range on record | 28-420 ft |
| Completion reports used | 587 |
| Texas state-wide average (weighted) | 282 ft |
| Estimated drilling cost at county median | $2,750-$7,150 |
Cost estimate is the county median depth (110 ft) times HomeAdvisor's national $25-$65 per-foot drilling range, cited on our cost guide. It covers drilling only, not casing, pump, or pressure tank, and it is a planning range, not a quote. Try the well cost estimator with this county's median pre-filled as a starting point.
Frequently asked
How deep is a well in Howard County, TX?
The median residential well in Howard County is 110 ft deep, based on 587 completion reports filed with the Texas Water Development Board. Most wells fall between 60 and 260 ft; the deepest on record is 420 ft.
How much does it cost to drill a well in Howard County?
Using the county's 110 ft median depth and the national $25-$65 per foot drilling range HomeAdvisor reports, a well drilled to the local median would run roughly $2,750 to $7,150 for drilling alone, before casing, pump, or pressure tank. That is a planning range, not a quote, get quotes from licensed local contractors for your property.
Who can drill a well in Howard County, TX?
Check any contractor's current license status before hiring; requirements vary by state. See our guide on how to hire a licensed well driller, or browse listed contractors serving Texas.
Ready to get quotes for your property?
Tell us about your project and we'll pass your details to a well driller serving Howard County, TX.
Request a QuoteOr browse well drilling companies in Texas.
See the full Texas well depth by county table, or the guide to hiring a licensed well driller.