Home › Pennsylvania › Well Depth by County › Fulton County
How Deep Are Wells in Fulton County, PA?
The median residential well in Fulton County is 204 ft deep, based on 1,339 completion reports filed with the Pennsylvania Department of Conservation and Natural Resources. Most fall between 107 and 360 ft; the deepest on record is 804 ft.
That is 31 ft deeper than the Pennsylvania state-wide average of 173 ft (an n-weighted average across every Pennsylvania county with reported data). Depth depends on local geology, your own site could sit well outside Fulton County's typical range.
Source and method: Pennsylvania Department of Conservation and Natural Resources Pennsylvania Groundwater Information System (PaGWIS), via PASDA, extracted 2026-07-14. Figures include only wells recorded as residential (domestic) use, with a reported depth between 15 and 2,000 ft (to exclude likely data-entry errors). PaGWIS carries no completion date, so figures cover all domestic wells on record rather than only recent ones, and the records are compiled from driller-submitted and historical sources at varying reliability that DCNR does not independently verify. These are figures self-reported by licensed drillers to the state; treat this as a planning reference, not a guarantee for any specific property.
Fulton County well depth at a glance
| Metric | Value |
|---|---|
| Median depth | 204 ft |
| Typical range (10th-90th pct) | 107-360 ft |
| Full range on record | 22-804 ft |
| Completion reports used | 1,339 |
| Pennsylvania state-wide average (weighted) | 173 ft |
| Estimated drilling cost at county median | $5,100-$13,260 |
Cost estimate is the county median depth (204 ft) times HomeAdvisor's national $25-$65 per-foot drilling range, cited on our cost guide. It covers drilling only, not casing, pump, or pressure tank, and it is a planning range, not a quote. Try the well cost estimator with this county's median pre-filled as a starting point.
Frequently asked
How deep is a well in Fulton County, PA?
The median residential well in Fulton County is 204 ft deep, based on 1,339 completion reports filed with the Pennsylvania Department of Conservation and Natural Resources. Most wells fall between 107 and 360 ft; the deepest on record is 804 ft.
How much does it cost to drill a well in Fulton County?
Using the county's 204 ft median depth and the national $25-$65 per foot drilling range HomeAdvisor reports, a well drilled to the local median would run roughly $5,100 to $13,260 for drilling alone, before casing, pump, or pressure tank. That is a planning range, not a quote, get quotes from licensed local contractors for your property.
Who can drill a well in Fulton County, PA?
Check any contractor's current license status before hiring; requirements vary by state. See our guide on how to hire a licensed well driller, or browse listed contractors serving Pennsylvania.
Ready to get quotes for your property?
Tell us about your project and we'll pass your details to a well driller serving Fulton County, PA.
Request a QuoteOr browse well drilling companies in Pennsylvania.
See the full Pennsylvania well depth by county table, or the guide to hiring a licensed well driller.